
ServicesScreen Cleaning & Repair
Window Screen Cleaning & Repair in Ridgeville
Dirty, torn or loose screens make clean glass look dull and let bugs in. We wash the mesh by hand, replace damaged screen and spline, straighten or rebuild frames, and tell you in writing which screens need what before any work begins.
Screens that let light and air through again
Every window screen is built from three parts. Mesh is stretched across a lightweight metal frame, and a flexible strip called spline is rolled into a channel around the edge to lock the mesh in place. Each part fails in its own way. Pollen, dust and mildew build up in the weave until the screen reads gray from the curb. Spline hardens and shrinks with sun and heat, so the mesh goes loose. Frames kink when a screen gets pried out with a screwdriver or leaned on.
We handle the cleaning side and the repair side. A wash clears the film that plugs the weave and cuts airflow. Screens that are beyond a wash usually get rescreened, with new mesh and new spline set into the frame you already own, rather than swapped for a whole new unit.
Every screen gets looked at before work begins, and what it needs goes on paper. The list shows which ones get washed, which get new mesh and which have frame damage, along with what drives the price for each. Once we start, the scope stays where it was written.
What our screen work includes
Hand washing the mesh
We lay each screen flat and wash both sides with a soft brush and mild detergent, then rinse at low pressure. High pressure stretches fiberglass mesh and can pop it out of the spline groove, so we keep it gentle.
Frame and channel cleaning
Grime packs into the frame corners and the spline channel. We clean those too, because dirt left in the corners runs back onto the mesh the first time it rains.
Rescreening torn or sagging mesh
We pull the old spline, remove the damaged mesh and roll in new screen with fresh spline sized to your frame groove. Standard fiberglass mesh is the usual choice, and we can talk through aluminum or heavier pet-resistant mesh if a screen takes a lot of abuse.
Frame straightening and corner repair
Slightly bent aluminum frames can often be trued by hand. Cracked plastic corner keys get replaced so the frame stays square and the new mesh pulls evenly.
Hardware and refitting
Missing pull tabs, worn tension springs and loose retainer clips are why many screens rattle or fall out. We replace that small hardware and set each screen back in its window so it sits snug.

Signs your screens need cleaning or repair
- Windows look hazy even after a wash
- If freshly cleaned glass still looks dull from outside, the screen is usually the cause. A coat of dust and pollen on the mesh sits right in your line of sight.
- Yellow or green film on the mesh
- Spring pine pollen and summer humidity leave a film that turns to mildew if it stays wet. Once it sets into the weave, rain will not rinse it out.
- Tears, holes or pulled corners
- Even a small hole lets mosquitoes and gnats in. Mesh pulling away at one corner usually means the spline has shrunk or cracked.
- Mesh that bellies or ripples
- Slack screen is a spline problem, not a dirt problem. New spline restores the tension.
- Screens that rattle, gap or fall out
- A gap along one edge points to a bent frame or a dead tension spring. Both are fixable without a new screen.
How a screen visit runs
- 1
Walk-around and written scope
We pull or inspect each screen and note its condition window by window. You get a written list showing what each screen needs and why, before any work starts.
- 2
Removal and labeling
Screens come out carefully and get marked by window, since screens that look identical often differ by a fraction of an inch.
- 3
Washing and repair
We wash screens on a clean surface in your driveway or yard, then rescreen or repair the ones on the list. Repaired screens get a tension check before they go back.
- 4
Refit and cleanup
Each screen returns to its own window and gets checked for a snug fit. We rinse the work area and haul off old mesh and spline.
How we price screen cleaning and repair
Two things set most of the price: the total count of screens, and how many of them need new mesh instead of a wash. Each factor below appears on your written quote, so the total is easy to trace line by line. If pulling a screen reveals damage we did not catch at first, we show it to you and get your okay before adding any work.
- Number and size of screens
- Twenty standard bedroom screens price differently from a handful of oversized or patio door screens. Bigger screens use more mesh and take more handling to wash and refit.
- Cleaning versus rescreening
- A wash is the lighter job. Rescreening means new mesh, new spline and more time on each frame.
- Mesh type
- Standard fiberglass is the common choice. Aluminum, solar or pet-resistant mesh costs more and handles differently on the table.
- Frame condition and hardware
- Bent frames, cracked corner keys and missing springs or pull tabs add parts and labor, and each one gets its own line.
- Access
- Second-story screens that only come out from outside, or screens tucked behind shrubs, take longer to remove and set back.
Screen cleaning and repair questions
- Can you repair a screen, or do I need a new one?
- Most damage is fixable by rescreening the existing frame with new mesh and spline. A new frame only makes sense when the old one is badly kinked or corroded. We tell you which is which in the written scope, and we do not push a replacement a repair would handle.
- Why do my screens get so dirty so fast?
- Fine mesh works like a filter. It catches pollen, dust and road grime, and humidity helps that layer stick and grow mildew. Screens near trees or on the side facing prevailing wind usually look worst.
- Should I get screens cleaned at the same time as my windows?
- It works best that way. Clean glass behind a dirty screen still looks dull, and a clean screen over dirty glass does the same. Many customers pair this with residential window cleaning and window track and sill cleaning so the whole opening is done at once.
- Will washing damage older screens?
- Not with hand washing at low pressure. Brittle mesh or dried spline can tear when handled, though. If we see that on the walk-around, we note it and let you decide whether to wash it or rescreen it.
- Do you handle patio and sliding door screens?
- Yes. Sliding screen doors get the same mesh and spline work, plus a look at the rollers and track so the door slides without binding.

Get a clear look at what your screens need
Tell us how many screens you have and what you are seeing. We will explain how we price the work and set up a time to inspect and write up each screen.